Hybridic aliphatic polyurethane water-based varnish used for the protection of microcement coatings on walls or light traffic floors. It provides a “satin” appearance to the surface. It is applied in two layers (the first diluted 1/1 in water). It is also applied in one layer (1/1 in water) prior to the application of two layers of PLANOFINISH PU 2KS, PLANOFINISH PU 2KS MAT or PLANOFINISH PU 2KW MAT aliphatic polyurethane varnishes in order to enhance protection against colour alteration of the coating in areas with heavy use.
• DRY BRIGHT is suitable for:
o concrete and cement mortars
o natural stones, renders and masonry plasters
o microcement screeds of PLANOCOLOR MICROCEMENT system
o porous building materials such as sand stones, bricks
o on mineral surfaces as a primer to prevent discoloration before applying solvent-based polyurethane varnishes
• Form: liquid
• Density: 1,0 ± 0,1 kg/L
• Application temperature: from +10°C up to +30°C
Substate preparation:
The application surface must be clean, free of dust, grease, old coatings, loose elements, solid and dry with a residual moisture limit <4% by weight.
Application:
DRY BRIGHT is applied with roller, spray or brush in two layers. The application surface must be dry, clean, free of dust and in general materials which might compromise adhesion. The first layer is applied diluted with water in a 1: 1 volume ratio. The second layer is followed by drying the first one, after about 1-2 hours, depending on the weather. Spraying is done with suitable equipment 25-30 cm from the surface, making sure the material is absorbed until saturated. On vertical surfaces, it is recommended that the application be done from top to bottom and when applied outdoors no strong winds must be present. Surfaces treated with DRY BRIGHT must be protected for at least 5 hours from rain and high temperatures.
Recommendations:
• Avoid direct exposure to sunlight and/or strong wind and rain
• Do not apply when the substrate & ambient temperatures are lower than +5°C and higher than +35°C
• Do not apply on surfaces with humidity above 4%
• In natural stones it is recommended to perform a trial test before
• Between the two layers is recommended the careful removal any dust
• The application is recommended by a professional user
Legal Notice:
The technical data and recommendations included or listed are the outcome of laboratory measurements combined with our current knowledge and expertise. All information and specifications should in any case be considered as indicative. The Company makes every effort to ensure the accuracy of the information provided herein. Product specifications are subject to change without notice and may differ from product images. Due to printing and application procedures, the colors displayed here should be considered as indicative. In particular, variations in materials, substrates and on-site application conditions are such that no warranty can be given or implied reference to the suitability of the materials for trading or use for a particular purpose and conditions of any given project. Anyone interested in using the product must ensure beforehand that the product is suitable for the intended use and in any case, the user is solely responsible for any outcomes associated with the use of product. Among other things, the Company is not responsible for any normal wear or tear from environmental or any other unsuitable conditions. We reserve the right to revise or change the data herein without prior notice. Restrictions and disclaimers apply to the extent permitted by applicable law. The Company has a Technical Support Department, which has exclusive responsibility for providing technical advice and solutions, addressing relevant issues. Requests to the Technical Support Department are addressed and answered, only in writing. For the latest and valid version of the Technical Data Sheet, the user of the material must refer to our website www.novamix.gr.
Back